The Homefill II

The Homefill II is a device that compresses the oxygen it receives from a concentrator into the cylinder connected to it.

The Compressor
The Homefill II is a compressor that fills ML6 or M9 tanks.  The compressor is easy to operate.  After turning on both the concentrator and compressor, place an empty cylinder in the compressor's cradle and connect it to the compressor. The five indicator lights on the compressor's control panel monitor the filling process to completion and note any problems along the way. When the process is complete, the color of the lights assures you of the amount and purity of the oxygen in the cylinder.

It takes up no more floor space than your concentrator if you purchase the optional table. Set the table over your concentrator and place the Homefill II on top.

The Concentrator
The concentrator that accommodates the  Homefill II is Invacare's Platinum 5, a 5 Lpm concentrator. This concentrator can support your oxygen needs up to 3 Lpm while simultaneously allowing Homefill II to fill a cylinder.

The Cylinders The Homefill II will fill only those cylinders that come with it, which are the M6 (or B), ML6, and M9 (or C) cylinder. Each cylinder has a contents gauge and a pneumatic conserver that are permanently attached to the cylinder.

The Contents Gauge
The contents gauge measures the internal pressure of the cylinder. When full, the internal pressure is 2000 psi (pounds per square inch), and the gauge's pointer is in the green area. When the pressure falls below 500 psi, the pointer is in the red area, indicating that in a very short time, the cylinder needs to be replaced.

Click here to view the Homefill II brochure